You probably do it all the time; I know I do. You set up the perfect view, for a render, in Photoview 360 and create a render, only to have to make a small change to the model for a new render. You then go back and spend a few minutes trying to recreate the same angle. This can be easily avoided by employing one of two simple methods. The first is simply saving a new view, which you will be able to revert back to whenever needed, and the second is to create a new camera. I tend to prefer creating a camera as it gives you quite a bit of control over the perspective within the view, as well as being able to edit the camera as needed. Check out the video below on creating a camera view in SolidWorks: