1. Getting Started with SolidWorks 0hr 28m 57s
- The SolidWorks Interface 07m 06s
- Working with Assemblies 09m 59s
- Working with Drawings 05m 56s
- Managing File References 05m 56s
You must be a member to view this video
Each set of videos contains free sample content. Simply click on the blue links to view them. Become a member for full access.
2. Designing a Coffee Table 0hr 51m 17s
- Coffee Table Introduction 09m 42s
- Creating the Initial Geometry 10m 43s
- Design Modifications 11m 30s
- Bracket SimulationXpress Study 05m 40s
- Adding Legs and a Bracket 13m 42s
- Exercise: Working with Extrusions
https://solidwize.com/wp-content/uploads/2013/09/2.5.1-SolidWize-ExtrusionExercise.pdf
You must be a member to view this video
Each set of videos contains free sample content. Simply click on the blue links to view them. Become a member for full access.
3. Appendix 0hr 34m 06s
- Customizing Toolbars and Shortcuts 09m 02s
- Creating Custom Templates 06m 30s
- Working with the Settings 08m 43s
- Backup and Autorecover Settings 06m 41s
- Saving Your Settings 03m 10s
You must be a member to view this video
Each set of videos contains free sample content. Simply click on the blue links to view them. Become a member for full access.
This section is for subscribers only.
Subscribers are provided with the same SolidWorks files that Rohit uses during each tutorial. Make the most of your learning experience by following along with each lesson.
If you are new to SOLIDWORKS, this is the place to start. This section will cover the navigating the interface, getting SOLIDWORKS setup, and getting started with modelling. This section also goes, briefly, how to go about managing your SOLIDWORKS files and setting up backup and autorecover. Important takeways from Intro to SOLIDWORKS:
- Setup the interface and shortcuts to improve your workflow
- Use custom templates
- Save your settings and get backup and autorecover setup
- SOLIDWORKS Files are going to be fully associative to each other wherever used